ENGLISHCHINESE

contact / contact us

Electric: 86 0577 86860899
Mobile phone: 13777778828
Fax:86 0577 86857808
Address: Longwan District of Wenzhou city Zhejiang Road West Wing Chinese No. 180

Laser marking machine routine maintenance

Times:        Date:2016-06-25

Laser marking machine does not work, should be cut off marking machine and computer.

Laser marking machine does not work, it will cover the field of the lens cap to prevent dust contamination of optical lenses.

When the unit is operating circuits are high pressure, non-professionals, not at boot maintenance, in order to avoid electric shock.

Laser marking machine any failure cut off the power immediately.

Laser marking machine equipment long time, dust in the air will be adsorbed on the microscope focus on the end surface, the light will reduce the laser power, the impact of marking results; causing heavy heat over temperature optical lens that burst. When poor marking results, you should carefully check the focusing mirror surfaces for contamination.

If the focusing mirror surface is contaminated, remove the focusing mirror clean its lower surface.

Remove the focusing mirror should be particularly careful, be careful not to damage or fall; at the same time, do not touch the hand or other articles focusing mirror mirror.

Cleaning method is anhydrous ethanol (AR) and diethyl ether (AR) of 3: 1 ratio mixed with long fiber cotton swab or lens paper invasion mixture, gently scrub focus microscope end surface, wipe each side, must be replaced once a cotton swab or lens paper.

In marking machine operation, marking machine can not move, so as not to damage the machine.

Do not cover the marking on the heap or put other items, so as not to affect the cooling effect of the machine.